If paper remains in the printer, press the Load/Eject button to eject the printed page.

To end the self test, press the Pause button to stop printing. To resume the test, press the Pause button again. To temporarily stop the self test, press the Pause button. When using single-sheet paper, load paper in the printer.Īfter a few seconds, the printer loads the paper automatically and begins printing the self test. Either self test can help you determine the source of your printing problem however, the draft self test prints faster than the letter-quality test. To run the test using the printer's letter-quality fonts, turn on the printer while holding down the Load/Eject button. To run the test using the Draft font, turn on the printer while holding down the LF/FF button. Whenever you turn off the printer, wait at least five seconds before turning it back on otherwise you may damage the printer. When using continuous paper, make sure paper is loaded, and the paper release lever is set to the correct position. See Loading Continuous Paper or Loading Single Sheets for paper-loading instructions.įollow these steps to perform a self test: You can print the self test using either single sheets or continuous paper. See Problems and Solutions for possible causes and solutions to the problem. If the self test does not print properly, there is a problem with the printer. (Be sure to use a shielded interface cable.) If the self test results are satisfactory, the printer is working properly and the problem is probably caused by your printer driver settings, application settings, computer, or interface cable. Running the printer's self test helps you determine whether the printer or the computer is causing the problem:

Epson l3110 self test print